The Command Access PD15-M storefront exit device is a high quality, cost effective way to acheive fast, quiet and smooth electric latch pullback in a storefront application. Our MM module technology provides low-current draw circuitry that allows the installer to power the device with virtually any 1A (or greater) 24VDC, regulated power source, eliminating the need for a costly, high-surge current speciality power supply. This device is offered in Concealed Vertical Rod (CVR) and RIM designs and is available in aluminium or duronatic finishes. As a retrofit solution, the PD15-M easily converts an existing Jackson 1285/1295 series or an AHT 8000/9000 series installation to a Command Access latch pullback application. The PD15 is designed to utilize the existing mounting locations (all models) as well as the rod & case assembly (CVR) without having to remove the door. With efficient electronics and cost effective designs, the Command Access PD15 devices are profitable solutions.
Door is secure without power. Door is unlatched electronically. Latchbolt retracted by pushpad inside or electronically by adding power. Optional key cylinders and/or exit trim are available to retract the latchbolt from the outside
Fast, quiet and smooth operation
Low surge current draw
MM module is compatible with most 24VDC, 1A (or greater) regulated power supplies and features an electronic travel adjustment to fine tune latch bolt pull back.
Auto re-lock if dogged push pad is pulled from position
Electronic adjustment for fine tuning latch bolt travel
6’ cable with Quick Connect for MM module
Up to 700’ wire run with 2/18 wire
3-year “no hassle” warranty
REX - Request to Exit switch available factory installed or as a field installable kit
LBM - Latch Bolt Monitor switch available factory installed or as a field installable kit
Power Supplies for RIM device - PS1 for single door or two door simultaneous operation, PS2/PS2BB for up to two independently operated doors, P5-S8 for up to eight independently operated doors.
Power Supplies for CVR device - PS1 for single door
Non-handed RIM Device
Handed CVR device (must specify)
System protection – unit shutdown when voltage exceeds 30VDC
Current draw – 1A for 400ms, 125mA holding (dogged) thereafter